DAN-ET-102M

Coaxial Ethernet Transceiver

ET-101/102/102M/103 are IEEE 802.3 compatible Ethernet transceivers and generally equipped with a coaxial cable connector and a 15-pin D-type transceiver cable connector.  They are used to interconnect to network computers and to provide a simple, cheap, and flexible ways of attaching devices to the different kinds of LAN transmission medium.  ET-102 and ET-102M have the same features except that ET-102M is smaller than ET-102 in size.  Thus, it can be directly attached to the Network Interface Card (NIC) without using any transceiver cables.

ET-101 / ET-102 / ET-102M / ET-103

Filename:  n/a
Included Drivers:

n/a

• Model:  ET-101 / ET-102 / ET-102M / ET-103
• PC Supported:  n/a
• Standards:  IEEE 802.3 Ethernet
• Network Connector:

  ET-101	N-type connector, 15-pin D-type AUI
  ET-102	BNC connector, 15-pin D-type AUI
  ET-102M	BNC connector, 15-pin D-type AUI
  ET-103	TAP connector, 15-pin D-type AUI

• LAN Controller:  n/a
• Data Transfer Rate:  10Mbps
• Duplex:  Half
• Cable:  RG-11, RG-58A/U
• LEDs:  All models contain 5 LEDs except ET-102M (PWR LED only)

  PWR	ON when +12V power coming from transceiver cable
  TX	Blinks to indicate that data is being transmitted to coaxial cable
  RX	Blinks to indicate that data is being received from coaxial cable
  CD	Normally OFF, blinks to indicate the presence of collision
  SQE	OFF means disable and ON means enable

• Power Requirement:  +12V via AUI port
• Ambient Temperature:  0° to 50° C
• Humidity:  n/a
• Dimensions:  (H x W x D)

  ET-101	30 x 89 x 106 mm
  ET-102	30 x 87 x 106 mm
  ET-102M	21 x 53 x 94 mm
  ET-103	30 x 85 x 115 mm

• EMI Rating:  FCC Part 15 Class A and CE Mark

Copyright ® 2000 Danpex Corp.  All rights reserved.
All information is subject to change without notice.