OPT-G4OAC15

G4OAC15 G4 AC Output 12-140 VAC, 15 VDC Logic

Opto 22’s G4 AC output modules are used to control or switch AC loads. Each module provides up to 4000 volts of
optical isolation (transient) between field outputs and the control side of the circuit, and each features zero voltage turn-
on and zero current turn-off. This AC output module is equivalent to a single-pole, single-throw, normally open contact
(Form A, SPST-NO).

Typical applications for AC output modules include switching loads such as AC relays, solenoids, motor starters,
heaters, lamps, and indicators.

	Units	G4OAC15	G4OAC15A	G4OAC24	G4OAC24A
Nominal line voltage	VAC	120	120/240	120	120/240
Output voltage range	VAC	12-140	24-280	12-140	24-280
Key feature	—	—	—	—	—
Current rating: At 45 °C ambient At 70 °C ambient	A A	3 2	3 2	3 2	3 2
UL Motor Load Rating	A	1.5	1.5	1.5	1.5
Isolation input-to-output (transient): 1 ms 1 minute	volts	4000 1500	4000 1500	4000 1500	4000 1500
Off-state leakage at nominal voltage (60 Hz)	mARMS	5	1.25/2.5	5	1.25/2.5
Logic voltage range	VDC	10.5-16	10.5-16	19.5-32	19.5-32
Logic pickup voltage	VDC	10.5	10.5	19.5	19.5
Logic dropout voltage	VDC	1	1	1	1
Logic input current at nominal logic voltage	mA	15	15	18	18
Control resistance (Rc in schematic)	ohms	1 K	1 K	2.2 K	2.2 K
One-cycle surge	A peak	80	80	80	80
Turn-on time @ 60 Hz	micro- seconds	≤8.3*	≤8.3*	≤8.3*	≤8.3*
Turn-off time @ 60 Hz	micro- seconds	≤8.3**	≤8.3**	≤8.3**	≤8.3**
Peak repetitive voltage	VAC	500	500	500	500
Minimum load current	mA	20	20	20	20
Output voltage drop maximum peak	V	1.6	1.6	1.6	1.6
Operating frequency	Hz	25-65	25-65	25-65	25-65
dV/dT-off-state	V/micro- second	200	200	200	200
dV/dT-commutating	--	snubbed for 0.5 power factor load	snubbed for 0.5 power factor load	snubbed for 0.5 power factor load	snubbed for 0.5 power factor load
Temperature Operating Storage	°C °C	-30 to +70 -30 to +85	-30 to +70 -30 to +85	-30 to +70 -30 to +85	-30 to +70 -30 to +85
* One-half cycle maximum. Module turns on at the zero volt crossing of the AC sine wave. ** One-half cycle maximum. Module turns off at the zero current crossing of the AC sine wave.