OPT-SNAP-UP1-D64

SNAP-UP1-D64 SNAP Ultimate controller/brain, digital only, for ioProject systems

NOTE: Although fully supported and still in production, this is a legacy product and not recommended for new designs.
For new designs, the SNAP-PAC-R2 on-the-rack controller has the same simple digital capability as the SNAP-UP1-D64
but can also handle 16- and 32-channel digital, plus analog and serial modules. It is also more powerful.
The SNAP-PAC-R1 uses a SNAP PAC rack.
 
-------------
 
The SNAP-UP1-D64 controller/brain is a programmable I/O and communications processor. It can be used as a
rack-mounted controller or as an I/O unit in a larger control system based on a more powerful Opto 22 controller, such
as the SNAP-PAC-S1.
 
Used as a rack-mounted controller, the SNAP-UP1-D64 is programmed using the legacy ioProject Basic software suite,
which is included in the purchase price. The newer PAC Project software suite was designed for SNAP PAC controllers
but also offers limited support for SNAP Ultimate I/O.
 

Power Requirements	5.0 VDC to 5.2 VDC at 1.2 A maximum (does not include module power requirements)
Processor	32-bit ColdFire 5407
Memory   Total RAM   Battery-backed RAM   Flash EEPROM	16 MB 512 KB 8 MB
Backup battery	CR2032, fixed (not user replaceable)
Network Interface	IEEE 802.3 network, 10Base-T and 100Base-TX
Serial Port	RS-232
Serial Data Rates	Default is 19,200 baud; baud rate is soft-selectable from 150 to 115,200 baud.
Maximum Ethernet Segment Length	100 meters with Category 5 or superior UTP. For 100 Mbps at this distance, use Category 5 or superior solid UTP.
Jumpers (Internal)	Boot to kernel/boot to loader Reset to factory defaults
Temperature:   Operating   Storage	0 °C to 70 °C -40 °C to 85 °C
Humidity	0–95% humidity, non-condensing