OPT-SNAP-LCSK

SNAP-LCSX SNAP Controller with Two COM Ports for FactoryFloor systems

NOTE: This is a legacy product and is not recommended for new development. We recommend using the SNAP-PAC-S1
standalone controller and the PAC Project Professional software suite instead of the SNAP-LCSX and FactoryFloor. SNAP
PAC S-series controllers with PAC Project Pro offer a migration path for legacy mistic systems. The S-series controller is
about the same size as the LCSX but provides more power and offers more features, including Ethernet network
connections.
 
------------
 
The SNAP-LCSX controller provides real-time industrial control in a small footprint. It is designed to work with the
FactoryFloor software suite and with SNAP brains, racks, and analog and digital SNAP I/O modules.
 
The SNAP-LCSX is NOT compatible with the PAC Project Software suite.
 

Item	Specification
CPU	32-bit Motorola 68EC020 processor
CPU clock frequency	16.67 MHz
Memory   RAM   Flash ROM	1 MB with battery backup 256 KB
RAM/clock battery	3.6-volt lithium, non-rechargeable, user replaceable, p/n G4BATT32
I/O	Opto 22 remote I/O using RS-485
Communication	COM 0: jumper selectable as RS-232 or RS-485, 2-wire or 4-wire. Modem control signals are present for RS-232 (RTS, CTS, DTR, DCD, and R). Pull-up, pull-down, and termination are jumper selectable for RS-485 operation, allowing multidrop operation.   COM 1: dedicated Opto 22 remote I/O port (2-wire RS-485 with interrupt capability)   COM 2 and COM 3 (LCSX-PLUS only): jumper selectable RS-232 or RS-485. RS-232 signals include TX, RX, RTS, and CTS. RS-485 is either 2-wire or 4-wire, with selectable termination and biasing.   Note: All ports use low-noise slew-rate-limited drivers and are transient protected to 400 W.
Real-time clock	Clock/calendar, Epson 64613 with battery backup
Power requirements	5 VDC ± 5% at 500 mA (maximum)
Typical operating temperature	0 °C to 70 °C
Storage temperature	-40 °C to 85 °C
Humidity	5% to 95% relative humidity, non-condensing
Software	FactoryFloor (OptoControl, OptoDisplay, OptoServer, and OptoConnect) and Classic software (Cyrano, Mistic MMI, and MDS)
System monitor	Processor and power watchdog timers