Deutsch 
English CT-FE120
CorNet 100TX Fast Ethernet Adapter PCI
 | Supports: 100Mbps 100base-TX Fast Ethernet (IEEE 802.3u) 10Mbps 10base-T Ethernet (IEEE 802.3) 32 bit bus mastering Supports boot ROM Fully software configurable Drivers for QNX, Netware, Windows, etc. Diagnostic link LEDs Auto-negotiation for 100Mbps or 10Mbps operation on single RJ-45 network connector +5VDC, 0.5A typical |
- Uses 2 pairs of unshielded twisted pair cabling (category 5 for 100base-TX Fast Ethernet or category 3 for 10base-T Ethernet)
This 100Mbit extension to the Ethernet standard allows significantly increased network throughput over 2 pairs of category 5 twisted pair wiring. The CorNet Fast Ethernet products are guaranteed to work with QNX.
DESCRIPTION
This is a 32-bit Bus Mastering Fast Ethernet Adapter for the PCI bus. It supports both 100Mbps Fast Ethernet and 10Mbps Ethernet connections to allow a gradual upgrade to a network. If appropriate cabling is present, simply attach the cable to a 100TX Hub on the network. The adapter will switch automatically to whatever network it is attached. It supports jumperless Plug and Play configuration.
OPERATING ENVIRONMENT
- Power: +5V DC @ 0.5A max
- Operating Temperature: 0 to 40ºC
- Storage Temperature: 40 to 70ºC
- Operating Humidity: 10% to 90% (non-condensing)
- Storage Humidity: 5% to 90% (non-condensing)
LAN INTERFACE
- 32-bit bus mastering PCI 2.0 bus
- 100 or 10Mbps transmission rate
- I/0 mapped (set by PCI BIOS)
- Interrupts (set by PCI BIOS)
- ROM: Optional Boot ROM
- PnP jumperless configuration by PCI bus
- Autodetect 100 or 10 Mbps network
- Drivers for most popular networking operating systems
PHYSICAL SPECIFICATIONS
- PCB mounted low profile RJ45 connector
- LED indicator for link, green - indicates link is operating normally, yellow - indicates node activity
- Standard PCI adapter: 125mmx80mm (4.92"x3.15")
WARRANTY
- 5 years
INSTALLATION CONSIDERATIONS
ETHERNET
Twisted Pair Cable Type
- Category 3 or better unshielded twisted pair
- From node to hub: 100m (325 ft)
Total network span: 500m (1320 ft)
Based on recommended maximum of 5 links and 4 repeaters between nodes.
FAST ETHERNET
Twisted Pair Cable type- Category 3 or better unshielded twisted pair
- From node to hub: 100m (325 ft)
Total network span: 205m (670 ft)
CONFORMS TO THE FOLLOWING STANDARDS
- 100TX: IEEE 802.3u 100base-TX
- Ethernet: IEEE 802.3 10base-T
- EMC:
- EN55022:1994, CISPR 22 Class A
- EN50082-1
- IEC 801-2, 8KV Air
- IEC 801-3, 3V/m
- IEC 801-4, 0.5KV Signal line, 1KV Power line
- Bus
- PCI