Corman CT-E104

Corman CT-E104

CorNet 10base Ethernet Adapter ISA

This is a 16-bit Ethernet NE2000 compatible Adapter for the ISA bus. It supports jumperless configuration with an easy to use configuration program. It also supports Plug and Play configuration. It has jacks for unshielded twisted pair or coax connections to the network. The adapter is supplied with a QNX network driver, along with drivers for most other popular operating systems. A QNX network boot ROM is also available.

LAN Interface

• 8/16 bit ISA bus
• 10Mbps transmission rate
• NE2000 compatible
• Full or half duplex auto negotiation
• I/0 mapped (Can be set in the range from 200 to 3E0 in increments of 20)
• Interrupts (2, 3, 4, 5, 10, 11, 12, 15)
• ROM: Optional Boot ROM
• RAM: 16KB packet buffer
• Jumperless NE2000 configuration
• Configuration via PnP BIOS or supplied QNX and DOS setup programs
• Autodetect BNC or UTP interface
• Uses NE2000 drivers or provided drivers for most popular networking operating systems

Operating Environment

Power:	+5V DC @ 0.5A max
Operating Temperature:	0 to 55ºC
Storage Temperature:	-40ºC to 70ºC
Operating Humidity:	10% to 90% (non-condensing)
Storage Humidity:	5% to 90% (non-condensing)

Physical Specifications

• PCB mounted low profile RJ-45 and BNC Connectors
• LED indicator for link status: indicates link is operating normally
• Dimensions: 157mm x 60mm (6.18” x 2.36”)

Warranty

• 2 years

Installation Considerations
ETHERNET

Twisted Pair Cable

• Category 3 or better unshielded twisted pair
• Distance from node to hub: 100m (325 ft)
  Based on recommended maximum of 5 links and 4 repeaters between nodes.

Coax Cable

• Thin coaxial cable: RG-58A/U 50 ohm coaxial cable (0.2 inch diameter)
• Maximum Segment length: 185m (600 ft)
• Minimum Segment length: 0.5m (1.6 ft)
• Maximum number of coax segments between nodes: 5
5
• Maximum number of nodes per coax segment: 30
• BNC 50 ohm terminator required at each end of trunk and one must be grounded

Conforms to the Following Standards

Ethernet:	IEEE 802.3 10base-T and 10base-2
EMC:	EN55022:1998 EN61000-3-2:1995 EN61000-3-3:1995 EN50024:1998	CISPR 22:1997
Products are marked as certified to the CE standards.

ALSO AVAILABLE
CT-E001 QNX Boot ROM