SWD GmbH, Hardware und Software Distribution | Opto22 B2 | Industrielle Kommunikationstechnik kaufen

Beschreibung

B2 16-channel Analog Brain, Optomux Protocol

The B2 brain board is an intelligent processor that operates as a slave
device to a host computer via an RS-422/485 serial link. The B2 mounts
on Opto 22 I/O racks with header connectors to control Standard (G1)
analog I/O modules. The B2 uses the Optomux protocol.
Note that the E2 brain board is a drop-in replacement for the B2 and
adds Ethernet capability as well as support for multiple protocols,
including Optomux, Modbus/TCP and OptoMMP.

B1 Power Requirements	5 .0 - 5.2 VDC @ 0.5 amps (includes digital module requirements)
B2 Power Requirements	5 .0 - 5.2 VDC @ 0.5 amps (excludes analog module requirements*)
Operating Temperature	0 °C to 70 °C 95% humidity, non-condensing
Interface	RS-422/485 communications 50-pin female header connector to I/O mounting rack
Data Rates	300, 600, 1200, 2400, 4800, 9600, 19200, and 38400 baud
Range: Multidrop Repeat Mode	Up to 5,000 feet total length with up to 32 Optomux stations maximum. ** Up to 5,000 feet between stations with up to 256 Optomux stations maximum.
Communications	Full duplex, two twisted pairs, a signal common wire, and a shield
LEDs	Power, receive, and transmit
Jumper-selectable Options	Address (0 to 255) Baud rate Multidrop or repeat mode 2- or 4-pass protocol
** ±15 VDC ± 0.25 V required for the analog modules. Current depends on the number and type of modules installed. A 24 VDC power supply is required for analog modules that need a current loop source. * Extend line length and/or number of OPTOMUX stations with the AC30A/B network adapter.