Opto22 SNAP-AOD-29

SNAP-AOD-29 SNAP 2-Ch 5-60 VDC Time-Proportional Digital Output Module

The SNAP-AOD-29 module provides two channels of time-proportional output (TPO). The module converts an analog
value, such as a PID loop outpoint, to a digital on/off output. The outputs are used to switch or control DC loads such as
lamps or indicators, solenoids, relay coils, and PLC logic.
 
Each TPO channel can switch 0.5 A of load current ranging from 5 VDC to 60 VDC, over a period range of .25 seconds
to 64.25 seconds.
 
NOTE: The SNAP-AOD-29 module is not needed for intelligent remote SNAP I/O used with Allen-Bradley PLC systems
(IO4AB). Instead, use the built-in TPO function in the brain itself.
 

Input	12-bit serial data (each channel)
Switched Output   at 45 °C Ambient   at 70 °C Ambient	5 to 60 Volts DC 0.5 A 0.2 A
TPO Resolution	12-bit Each bit = Period/4095 1 millisecond/bit default
Period Range	0.251 sec. to 64.25 sec. (0.251 sec for Ethernet-based I/O units) 0.251 seconds module default
Period Accuracy	± 0.5%
Period Resolution	.251 second
Inhibit Inputs On   Off	4.0 Volts DC at 1.0 mA (32 Volts DC max. 1.0 Volt DC
Maximum Operating Common Mode Voltage	250 V
Common Mode Resistance	>1,000 Megaohms
Timebase Temperature Coeffi­cient	50 PPM/°C
Power Requirements	5 Volts DC (±0.15) @ 150 mA
Ambient Temperature:   Operating   Storage	0 °C to 70 °C -25 °C to 85 °C
Torque, hold-down screws	4 in-lb (0.45 N-m)
Torque, connector screws	5.26 in-lb (0.6 N-m)
Agency Approvals	UL, FM, CE, RoHS, DFARS
Warranty	Lifetime