SWD GmbH, Hard-+Software Distribution | Opto22 G4ODC5R5 | industrial communication hardware online

Description

G4ODC5R5 G4 Reed Relay Output, 5 VDC logic, normally closed

The G4ODC5R is a reed relay, low-contact-resistance DC output. It is a single-pole, single-throw, normally open
mechanical relay (Form A, SPST-NO). It was designed for a low-voltage DC load that is purely resistive (no inrush
current).

Typical applications for these modules include analog signal and communication line multiplexing. Because of their low
10 VA rating, these modules cannot be used with inductive or capacitive loads (even very small loads) nor 120 VAC.

If you need a Factory Mutual approved version of this module, see the G4ODC5R5FM.

	Units	G4ODC5R G4ODC5RFM*	G4ODC5R5 G4ODC5R5FM*
Contact form		Form A SPST mechanical relay	Form B SPST mechanical relay	NOTE: The application of the dry contact module must not exceed 10 VA under steady-state or momentary in-rush conditions. For voltages at or below 20 volts, the current limit is 0.5 amps. For voltages above 20 volts, the maximum allowable current is determined by the following equation: Maximum Current = 10 VA / Voltage
Normal position		Open	Closed
Contact rating	VA	10	10
Maximum switching voltage (see Note)	VDC	100	100
Maximum switching voltage (see Note)	VAC	130	130
Maximum switching current	A	0.5 (see Note)	0.5 (see Note)
Contact resistance	Milliohms	200	200
Turn-on time	microseconds	500	500
Turn-off time	microseconds	500	500
Contact bounce	microseconds	250	250
Mechanical life	cycles	5 million	5 million
Logic voltage range	VDC	4.8-6	4.8-6
Logic OFF voltage range	VDC	3.8-6	3.8-6
Logic ON voltage range	VDC	0.0â€“0.8	0.0â€“0.8
Indeterminate range	VDC	0.8â€“3.8	0.8â€“3.8
Logic input current at nominal logic voltage	milliamps	14	14
Isolation voltage (transient) input-to-output	VDC	1,500	1,500
Ambient temperature Operating: Storage:	°C °C	0 to +70 -60 to +105	0 to +70 -60 to +105
*Part numbers ending in FM are Factory Mutual approved.