DAN-CEM1500

10Base-FL ST Multi-Mode <> 10Base-T RJ-45 Ethernet Converter

OVERVIEW CEM1500 is an IEEE 802.3 Ethernet media converter between 10Base-FL and 10Base-T. It is designed to address the situation where only 10Base-T port is available but 10Base-FL connectivity via ST connectors is required. Such high performance media converter can repeat and convert data signal running 10Base-FL cable up to 2 km. The CEM1500 is equipped with two fiber optic ST connectors (one for transmitting - Tx and one for receiving - Rx) and one RJ-45 jack (switch selectable for MPR or DTE.) Four LED indicators are built-in for easy diagnostic and monitoring the status of Power, TP Link/Activity, Fiber Link/Activity, and Collision.

DEVICE DRIVERS SUPPORTED

Filename: n/a
Included Drivers:n/a

TECHNICAL SPECIFICATIONS

• Model:CEM1500
• PC Supported:n/a
• Standards:IEEE 802.3 Ethernet 10Base-FL and 10Base-T
• Network Connector:
  850nm ST Tx/Rx Multi-Mode Connectors and RJ-45 Jack (MPR/DTE Slide-Switch Selectable)
  (Both RJ-45 jack and ST connectors are located on the SAME end. Please refer to the picture shown above
• dBm
• Data Transfer Rate: 10Mbps
• Duplex:Half
• Cable:
  Fiber 50/125, 62.5/125µm multi-mode, and Category 3/4/5 Unshielded Twisted-pair
  Cable Limitation:

  Fiber optic cable	: 2 km
  UTP cable	:100 m

• LEDs: Fiber Link/ACT, TP Link/ACT, Power, and Collision
• Power Requirement: 1A@+5V DC
  External Power Adapter:100-240VAC, 50/60Hz, 0.5/0.25A
• Ambient Temperature: 0° to 50° C
• Humidity: 5% to 90%
• Dimensions:26.2 x 70.3 x 94 mm (H x W x D)
• EMI Rating: FCC Part 15 Class A and CE Mark